1. Ignition Switch
2. Joint Connector F
3. Stop Watch Button
4. Oil Pressure Switch
5. Crankshaft Sensor
6. Water Temperature Sensor
7. Gear Position Switch
8. Intake Air Temperature Sensor
9. ESD ECU (ZX1000JD/KD)
10. ECU
11. Rear Wheel Rotation Sensor
12. Frame Ground 1
13. Engine Ground
14. Battery 12 V 8.6 Ah
15. Main Fuse 30 A
16. Meter Fuse 10 A
17. Fuse Box 2
18. Frame Ground 3
19. Frame Ground 5
20. Frame Ground 4
21. KIBS Hydraulic Unit
22. Fuel Reserve Switch
23. Headlight Relay
24. Turn Signal Relay
25. Mode Switch
26. Dimmer Switch
27. Turn Signal Switch
28. Passing Button
29. Joint Connector D
30. Joint Connector C
31. Fuse Box 1
32. ESD Fuse 10 A (ZX1000JD/KD)
33. Turn Signal Relay Fuse 10 A
34. Brake Light/Horn Fuse 10 A
35. Headlight Relay Fuse 15 A
36. Ignition Fuse 15 A
37. Meter Unit
Warning/Indicator Lights
: When the
transmission is in
neutral, the neutral indicator light goes
on.
: When the
headlight is on high
beam, the high beam indicator light
goes on.
: When the
turn signal switch is
pushed to the left or right, the turn signal
indicator light blinks. ...
Main Throttle Sensor Resistance Inspection
Turn the ignition switch to OFF.
Measure the main throttle sensor resistance in the same
way as input voltage inspection, note the following.
Disconnect the throttle sensor setting adapter [A] from the
connector of the main harness side.
Special Tool - Throttle Sensor Setting Adapter: 57 ...
Air Switching Valve
Air Switching Valve Operation Test
Refer to the Air Suction System Damage Inspection in the
Periodic Maintenance chapter.
Air Switching Valve Unit Test
Remove the air switching valve (see Air Switching Valve
Removal in the Engine Top End chapter).
Set the hand tester [A] to the × 1 ...