Kawasaki Ninja Owners Manual: Moving Off

Kawasaki Ninja Owners Manual / How to ride the motorcycle / Moving Off

Check that the side stand is up.
Pull in the clutch lever.
Shift into 1st gear.
Open the throttle a little, and start to let out the clutch lever very slowly.
As the clutch starts to engage, open the throttle a littlemore, giving the engine just enough fuel to keep it from stalling.

A. Shift Pedal

NOTE

The motorcycle is equipped with a side stand switch. This switch is designed so that the engine does not start if the transmission is in gear and the side stand is down.
When the headlight is on high beam, two headlight beams go on, and on low beam, the one side of the headlight goes on.

Jump starting

If your motorcycle battery is “run down”, it should be removed and charged. If this is not practical, a 12 volt booster battery and jumper cables may be used to start the engine. DANGER Batt ...

Shifting Gears

Close the throttle while pulling in the clutch lever. Shift into the next higher or lower gear. Open the throttle part way, while releasing the clutch lever. For smooth riding, each gea ...

Other materials:

Exploded View
14. Thermostat 15. Frame No. JKAZXT00JJA003074 or JKAZXCJ1 BA003074 G: Apply grease. HG: Apply high-temperature grease. L: Apply a non-permanent locking agent. R: Replacement Parts S: Follow the specified tightening sequence. W: Apply water. 1. US, CA and CAL Models 2. Fra ...

Information for Coolant
To protect the cooling system (consisting of the aluminum engine and radiator) from rust and corrosion, the use of corrosion and rust inhibitor chemicals in the coolant is essential. If coolant containing corrosion and rust inhibitor chemicals are not used, over a period of time, the cooling ...

Special Tools
Inside Circlip Pliers: 57001-143 Oil Seal & Bearing Remover: 57001-1058 Bearing Driver Set: 57001-1129 Jack: 57001-1238 Bearing Remover Head, 15 × 17: 57001-1267 Fork Oil Level Gauge: 57001-1290 Bearing Remover Shaft, 13: 57001-1377 Fork Oil Seal Driver, 43: 57001-15 ...