Kawasaki Ninja Service Manual: Nozzle Assy

Throttle Body Assy Assembly

Before assembling, blow away dirt or dust from the throttle body and delivery pipe assy by applying compressed air. Replace the O-rings [A] of the joint pipe [B] with new ones. Apply engine o ...

Nozzle Assy Removal

Remove the fuel tank (see Fuel Tank Removal). Disconnect the secondary fuel hose [A] from the delivery pipe assy of the nozzle assy [B] (see Fuel Hose Replacement in the Periodic Maintenance ...

Other materials:

DFI Parts Location
Main Throttle Sensor [A] Subthrottle Sensor [B] Idle Speed Control Valve Actuator [C] Subthrottle Valve Actuator [D] Intake Air Pressure Sensor #2 [E] Stick Coils #1, #2, #3, #4 [F] Air Switching Valve [G] Intake Air Pressure Sensor #1 [H] Water Temperature Sensor [A] Primary Fuel Injec ...

Connecting Rod Big End Side Clearance Inspection
Measure connecting rod big end side clearance. Insert a thickness gauge [A] between the big end and either crank web to determine clearance. Connecting Rod Big End Side Clearance Standard: 0.13 0.38 mm (0.0051 0.0150 in.) Service Limit: 0.58 mm (0.023 in.) If the clearance exceeds ...

Steering Damper Installation
Install the following parts as shown in the figure. Collar [A] Washer (t = 3.5 mm, 0.14 in.) [B] Steering Damper [C] ( ZX1000JC/KC) Electronic Steering Damper [D] (ZX1000JD/KD) Washer (t = 1.2 mm, 0.05 in.) [E] Apply a non-permanent locking agent to the threads of the steering ...