A. Engine Oil Drain Bolt
A. Oil Filter
WARNING Engine oil is a toxic substance. Dispose of used oil properly. Contact your local authorities for approved disposal methods or possible recycling. |
Tightening Torque
Engine Oil Drain Bolt: 29 N·m (3.0 kgf·m, 21 ft·lb) Oil Filter: 17 N·m (1.7 kgf·m, 13 ft·lb)
Recommended Engine Oil
Type: Kawasaki Performance 4-Stroke Motorcycle Oil* Kawasaki Performance 4-Stroke Semi-Synthetic Oil* Kawasaki Performance 4-Stroke Full Synthetic Oil* or other 4-stroke oils with API SG, SH, SJ, SL, SM and JASO MA, MA1, MA2 rating Viscosity: SAE10W-40
*Kawasaki Performance Oils and Lubricants have been specifically engineered for your vehicle. Consistent use of these products meets or exceeds warranty and service requirements and can help to extend the life of your Kawasaki.
NOTE
Do not add any chemical additive to the oil. Oils fulfilling the above requirements are fully formulated and provide adequate lubrication for both the engine and the clutch.
Engine Oil Capacity
Capacity: 2.9 L (3.1 US qt) [when filter is not removed] 3.3 L (3.5 US qt) [when filter is removed] 3.7 L (3.9 US qt) [when engine is completely dry]
Although 10W-40 engine oil is the recommended oil for most conditions, the oil viscosity may need to be changed to accommodate atmospheric conditions in your riding area.
Torque and Locking Agent
The following tables list the tightening torque for the major fasteners
requiring use of a
non-permanent locking agent or silicone sealant etc.
Letters used in the “Remarks” column mean:
AL: Tighten the two clamp bolts alternately two times to ensure even tightening
torque.
G: Apply ...
Front Fork Inspection
Holding the brake lever, pump the
front fork up and down several times
to inspect smooth stroke.
Visually inspect the front fork for oil
leakage, scoring or scratches on the
outer surface of the inner tube.
If any doubt about the front fork, it
should be checked by an authorized
K ...
Oil Cooler Installation
Replace the O-ring [A] with a new one.
Apply grease to the new O-ring.
Install the water hoses and hose clamps [A] as shown in
the figure.
Water Hose (About 300 mm, 11.8 in.) [B]
Water Hose (About 130 mm, 5.1 in.) [C]
Yellow Paint [D]
Tighten:
Torque - Water Hose Clamp S ...