Kawasaki Ninja Service Manual: Oil Cooler Removal

Oil Cooler

...

Oil Cooler Installation

Replace the O-ring [A] with a new one. Apply grease to the new O-ring. Install the water hoses and hose clamps [A] as shown in the figure. Water Hose (About 300 mm, 11.8 in.) [B] ...

Other materials:

Air Cleaner Housing Assembly
Install the ducts to the air cleaner housing. Fit the projections [A] of the duct into the slits [B] on the air cleaner housing. Tighten the screws [A]. Torque - Air Cleaner Housing Duct Screws: 1.1 N·m (0.11 kgf·m, 10 in·lb) Install: Air Cleaner Gasket [A] Duct [B] ...

Axle Inspection
Remove the front and rear axles (see Front/Rear Wheel Removal). Visually inspect the front and rear axle for damages. If the axle is damaged or bent, replace it. Place the axle in V blocks that are 100 mm (3.94 in.) [A] apart, and set a dial gauge [B] on the axle at a point halfway ...

Spring Preload Adjustment
Remove the rear shock absorber from the frame (see Rear Shock Absorber Removal). Loosen the locknut and turn out the adjusting nut to free the spring. Special Tools - Hook Wrench T=3.2 R37: 57001-1539 Hook Wrench R=35: 57001-1580 To adjust the spring preload, turn in the adjusting n ...