If the oil filter holder bolt [A] was removed, tighten it.
Apply a non-permanent locking agent to the threads of the oil filter holder bolt.
Torque - Oil Filter Holder Bolt: 35 N·m (3.6 kgf·m, 26 ft·lb)
Blow away the particles by applying compressed air [B] from the inside to the outside (from the clean side to the dirty side).
WARNING Gasoline and low flash-point solvents can be flammable and/or explosive and cause severe burns. Clean the screen in a well-ventilated area, and take care that there are no sparks or flame anywhere near the working area; this includes any appliance with a pilot light. Do not use gasoline or a low flash-point solvent to clean the screen. |
NOTE
While cleaning the oil screen, check for any metal particles that might indicate internal engine damage.
If the screen is damaged, replace it.
Face the flanged side [B] to the bottom.
Lower Crankcase [C]
Face the knob of the clamp [F] inward as shown in the figure.
Viewed from Bottom [G]
Turn the chamfered side [C] downward.
Fit the claws [E] to the crankcase rib [F].
Torque - Oil Pan Bolts: 9.8 N·m (1.0 kgf·m, 87 in·lb)
Front [D]
Fuel Hose Inspection (fuel leak, damage, installation condition)
If the motorcycle is not properly handled, the high pressure
inside the fuel line can cause fuel to leak [A] or the
hose to burst. Remove the fuel tank (see Fuel Tank Removal
in the Fuel System (DFI) chapter) and check the
fuel hoses.
Replace the fuel hose if any fraying, cracks [B] or ...
Front, Rear Wheel Rotation Difference Abnormal Inspection (Service Code b
25)
Check the following and correct the faulty part.
Incorrect Tire Pressure
Tires not recommended for the motorcycle were installed
(incorrect tire size).
Deformation of Wheel or Tire
Missing Teeth or Clogging with Foreign Matter of Sensor
Rotor (see Wheel Rotation Sensor Rotor Inspe ...
Rear Fender Front Installation
Installation is the reverse of removal. Note the following.
Run the harness, cables and leads correctly (see Cable,
Wire, and Hose Routing section in the Appendix chapter).
When installing the clamp [A] on the rear fender front [B],
install it so that the clamp positions at near the ...