Kawasaki Ninja Service Manual: Oil Pressure Switch Removal

Kawasaki Ninja Service Manual / Engine Lubrication System / Oil Pressure Switch / Oil Pressure Switch Removal

Oil Pressure Switch Removal


Oil Pressure Switch
...

Oil Pressure Switch Installation
Using a high flash-point solvent, clean off any oil or dirt that may be on the silicone sealant coating area. Dry them with a clean cloth. Apply silicone sealant to the threads of the oil pre ...

Other materials:

Tire Air Pressure Inspection
Remove the air valve cap. Measure the tire air pressure with an air pressure gauge [A] when the tires are cold (that is, when the motorcycle has not been ridden more than a mile during the past 3 hours). Install the air valve cap. Adjust the tire air pressure according to the specifi ...

Idle Speed
The idle speed inspection should be performed in accordance with the Periodic Maintenance Chart. This motorcycle is equipped with the Idle Speed Control valve. If the idle speed is disturbed, inspection of the idle speed control should be done by an authorized Kawasaki dealer. NOTE While ...

Gear Position Switch Output Voltage Inspection
NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Remove the fuel tank (see Fuel Tank Removal in the Fuel System (DFI) chapter). Disconnect the sidestand switch/gear position switch lead connector [A]. Connect the measuring adapter [A] between the ...