Kawasaki Ninja Service Manual: Oil Pump Drive Gear Removal/Installation

Oil Pump Installation

Install the outer rotor [A] into the crankcase. Assemble: Oil (Water) Pump Shaft [B] Pin [C] Inner Rotor [D] To prevent dropping, apply grease to the pin. Install the inner rotor ass ...

Oil Pump Drive Gear Installation

Install is the reverse of removal. Note the following. First, engage the oil pump chain [A] to the gears, and then install the oil pump drive gear [B]. Turn the “OUT” mark [C] to outside. ...

Other materials:

Intake Air Pressure Sensor #2 Installation
NOTE The intake air pressure sensor #2 is the same part as the intake air pressure sensor #1. Installation is basically the reverse of removal. Position the intake air pressure sensor #2 [A] between the projections [B] on the rubber damper. Install the rubber damper [A] on the brac ...

Diode Circuit Inspection
Remove the relay box (see Relay Box Removal). Check conductivity of the following pairs of terminals (see Relay Box Internal Circuit in this section). Diode Circuit Inspection The resistance should be low in one direction and more than 10 times as much in the other direction. If any dio ...

Fuel Tank
The following octane rating gasoline is recommended for the fuel tank. Avoid filling the tank in the rain or where heavy dust is blowing so that the fuel does not get contaminated. A. Tank Cap B. Fuel Tank C. Top Level D. Filler Neck WARNINGGasoline is extremely flammable an ...