Kawasaki Ninja Service Manual: Overview

Kawasaki Ninja Service Manual / General Information / Technical Information-Sport-Kawasaki TRaction Control System (S-KTRC) / Overview

S-KTRC is a highly sophisticated system based on MotoGP racing technology. Unlike the KTRC system used on the GTR1400 ABS (Concours 14 ABS in N. America), which is designed to offer rider reassurance when traversing slippery surfaces, S-KTRC, is designed to maximize forward motion, allowing riding at the edge of traction.

The quickest acceleration requires a certain amount of slip, so in order to optimize traction, S-KTRC actually allows slip. The ideal slip ratio varies according to conditions. The system looks at a number of parameters to get an accurate real-time picture of what is going on: front and rear wheel speed (slippage), engine rpm, throttle position, slippage, acceleration, etc.

Using complex analysis, the system is able to predict when traction conditions are about to become unfavorable. By acting before slippage exceeds the range for optimal traction, drops in power can be minimized resulting in ultra-smooth operation.

There are three available modes that riders can set according to preference (and skill level). Each mode is able to accommodate a range of riding conditions. Of course, engine manageability is such that riders can opt to turn the system OFF without fear of making the bike uncontrollable.

By combining the setting with the power mode, the rider can choose various riding modes to suit the road conditions and riding skill.

The system becomes functional at 5 km/h (3.1 mph) or more. If a failure occurs in the system, the warning indicator light (yellow LED) and mode indicator symbol blink to let the rider know that the system stops functioning.

Overview


Technical Information-Sport-Kawasaki TRaction Control System (S-KTRC)
...

System Components
1. FI ECU The FI ECU analyzes the motorcycle conditions based on the signals from the front/rear wheel rotation sensors and FI sensors (such as the crankshaft sensor and main throttle sensor), and ...

Other materials:

KIBS Hydraulic Unit Installation
NOTICE Brake fluid quickly ruins painted plastic surfaces; any spilled fluid should be completely washed away immediately. Install the KIBS hydraulic unit together with the bracket. Before installing the brake pipe, check to see that there is no damage on the threads of the brake pipe joi ...

Subthrottle Sensor Output Voltage Inspection
Measure the output voltage at the subthrottle sensor in the same way as input voltage inspection, note the following. Disconnect the subthrottle sensor connector and connect the setting adapter [A] between these connectors. Special Tool - Throttle Sensor Setting Adapter: 57001 -1538 ...

Intake Air Pressure Sensor #1 Input Voltage Inspection
NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Remove the air cleaner housing (see Air Cleaner Housing Removal in the Fuel System (DFI) chapter). Disconnect the intake air pressure sensor #1 connector and connect the measuring adapter [A] between these con ...