NOTICE
Do not pull strongly, twist, or bend the oxygen sensor lead. This may cause the wiring open.
Passenger’s Seat Removal
Remove the passenger’s seat by inserting
the ignition key into the seat
lock, and turning it clockwise.
A. Seat Lock
B. Ignition Key
C. Passenger’s seat
D. Pull up
NOTE
When removing the passenger’s
seat, pull it up while turning the key. ...
Hub Bearing Installation
Before installing the hub bearings, blow any dirt or foreign
particles out of the hub with compressed air to prevent
contamination of the bearings.
Replace the bearings with new ones.
Install the bearings by using the bearing driver set which
does not contact the bearing inner race.
...
Brake Fluid Leak (Brake Hose and Pipe) Inspection
For KIBS equipped models, remove the fuel tank (see
Fuel Tank Removal in the Fuel System (DFI) chapter).
Apply the brake lever or pedal and inspect the brake fluid
leak from the brake hoses [A], pipes (KIBS equipped models)
[B] and fittings [C].
If the brake fluid leaked from any posit ...