Kawasaki Ninja Service Manual: Piston Installation

Kawasaki Ninja Service Manual / Crankshaft/Transmission / Pistons / Piston Installation

Spread the rail with your thumbs, but only enough to fit the rail over the piston.

Release the rail into the bottom piston ring groove.

NOTE

The oil ring rails have no “top” or “bottom”.

Piston Installation


NOTE

Do not mix up the top and second ring.

Piston Installation


NOTE

If a new piston is used, use new piston rings.

Piston Installation


When installing the piston pin snap ring, compress it only enough to install it and no more.

NOTICE

Do not reuse snap rings, as removal weakens and deforms them. They could fall out and score the cylinder wall.

Piston Installation


Special Tools - Piston Ring Compressor Grip: 57001-1095 Piston Ring Compressor Belt, 67

79:
57001-1097

Piston Installation


Piston Removal
Remove: Crankshaft (see Crankshaft Removal) Remove the piston together with the connecting rod to the cylinder head side. NOTICE Discard the connecting rod bolts and nuts. To prevent dam ...

Cylinder (Upper Crankcase) Wear Inspection
Split the crankcase (see Crankcase Splitting). Remove the pistons (see Piston Removal). Assemble the cylinder (upper crankcase) [A], the cylinder head [B] and the cylinder head gasket [C]. ...

Other materials:

Ignition Switch/Steering Lock
This is a three-position, key-operated switch. The key can be removed from the switch when it is in the OFF or LOCK position. A. Ignition Switch/Steering Lock B. ON position C. OFF position D. LOCK position NOTE The tail, city and license plate lights are on whenever the ignition key i ...

Technical Information - Electronic Steering Damper (ESD/ZX1000JD/KD models)
1) Overview This model has an Electronic Steering Damper (ESD) [A]. Unlike conventional manual adjustment method of Kawasaki, damping characteristics are adjusted by the electronic control unit. 2) Purpose Designed to offer increased stability at high speed without interfering with light ...

ESD (Electronic Steering Damper) ECU Communication Error (Service Code 3C, ZX1000JD/KD)
ESD ECU Communication Line Inspection When the data (for status of ESD system) is not sent from the ESD ECU to the meter unit and ECU, the service code 3C is displayed. The data is sent through the CAN communication line. The service code 3C is detected with the meter unit. The FI symbol does ...