Kawasaki Ninja Service Manual: Piston Wear Inspection

Kawasaki Ninja Service Manual / Crankshaft/Transmission / Pistons / Piston Wear Inspection

Measure the outside diameter [A] of each piston 5 mm (0.20 in.) [B] up from the bottom of the piston at a right angle to the direction of the piston pin.

If the measurement is under service limit, replace the piston.

Piston Wear Inspection

Piston Diameter

Standard: 75.959 75.974 mm
(2.9905 2.9911 in.)
Service Limit: 75.81 mm (2.985 in.)

Cylinder (Upper Crankcase) Wear Inspection

Split the crankcase (see Crankcase Splitting). Remove the pistons (see Piston Removal). Assemble the cylinder (upper crankcase) [A], the cylinder head [B] and the cylinder head gasket [C]. ...

Piston Ring, Piston Ring Groove Wear Inspection

Check for uneven groove wear by inspecting the ring seating. The rings should fit perfectly parallel to groove surfaces. If not, replace the piston and all the piston rings. With the pist ...

Other materials:

Spark Plug Condition Inspection
Remove the spark plugs (see Spark Plug Replacement in the Periodic Maintenance chapter). Visually inspect the spark plugs. If the spark plug center electrode [A] and/or side electrode [B] are corroded or damaged, or if the insulator [C] is cracked, replace the plug. If the spark plug is ...

Armature Inspection
Using the × 1 Ω hand tester range, measure the resistance between any two commutator segments [A]. Special Tool - Hand Tester: 57001-1394 If there is a high resistance or no reading (∞) between any two segments, a winding is open and the starter motor must be replaced. ...

Valve Clearance Adjustment
To change the valve clearance, remove the camshafts (see Camshaft Removal in the Engine Top End chapter) and valve lifters. Replace the shim with one of a different thickness. NOTE Mark and record the locations of the valve lifters and shims so that they can be reinstalled in their ...