If the battery is good condition, perform the Pre-Diagnosis Inspection 1 and 2 (see Inquiries to Rider in the Brakes chapter).
If this service code appears even if all checks are ended, replace the KIBS hydraulic unit.
If the service code does not appear, the KIBS system normal (temporary failure).
Rear Wheel Rotation Sensor Wiring Inspection (Service Code b 45)
Power Supply Voltage Inspection (Over-Voltage) (Service Code b 53)Caliper Fluid Seal Damage
The fluid seal (piston seal) [A] is placed around the piston
to maintain clearance between the pad and the disc. If
the seal is in a poor condition, it could lead the pad to wear
excessively or the brake to drag, which may cause the temperature
of the discs or the brake fluid to increase.
Re ...
Evaporative Emission Control System Inspection (CAL and SEA-B1 Models)
Inspect the canister as follows.
Remove the upper fairing assembly (see Upper Fairing
Assembly Removal in the Frame chapter).
Remove the canister [A].
Visually inspect the canister for cracks or other damage.
If the canister has any cracks or bad damage, replace it
with a new one.
NO ...
Brake Light Switches
When either the front or rear brake is
applied, the brake light goes on. The
front brake light switch requires no adjustment,
but the rear brake light switch
should be adjusted in accordance with
the Periodic Maintenance Chart.
Inspection
Turn the ignition key to “ON”.
The brake ligh ...