Kawasaki Ninja Service Manual: Precautions

Kawasaki Ninja Service Manual / Electrical System / Battery / Precautions

1) No need of topping-up

No topping-up is necessary in this battery until it ends its life under normal use. Forcibly prying off the seal cap to add water is very dangerous. Never do that.

2) Refreshing charge.

Give refresh charge for 5 to 10 hours with charge current shown in the text (see Refreshing Change).

When a fast charge is inevitably required, do it following precisely the maximum charge current and time conditions.

NOTICE

This battery is designed to sustain no unusual deterioration if refresh-charged according to the method specified above. However, the battery’s performance may be reduced noticeably if charged under conditions other than given above. Never remove the seal cap during refresh charge.

If by chance an excessive amount of gas is generated due to overcharging, the relief valve releases the gas to keep the battery normal.

3) When you do not use the motorcycle for months.

Give a refresh charge before you store the motorcycle and store it with the negative cable removed.

Give a refresh charge once a month during storage.

4) Battery life.

If the battery will not start the engine even after several refresh charges, the battery has exceeded its useful life. Replace it (Provided, however, the vehicle’s starting system has no problem).

DANGER

Batteries produce an explosive gas mixture of hydrogen and oxygen that can cause serious injury and burns if ignited. Keep the battery away from sparks and open flames during charging. When using a battery charger, connect the battery to the charger before turning on the charger. This procedure prevents sparks at the battery terminals which could ignite any battery gases. The electrolyte contains sulfuric acid. Be careful not to have it touch your skin or eyes. If touched, wash it off with liberal amount of water and seek medial attention for more severe burns.

Battery Installation
Visually inspect the surface of the battery container. If any signs of cracking or electrolyte leakage from the sides of the battery. Put the battery into the rear fender Install the band ...

Interchange
A sealed battery can fully display its performance only when combined with a proper vehicle electric system. Therefore, replace a sealed battery only on a motorcycle which was originally equipped ...

Other materials:

Throttle Body Assy Holder Installation
Be sure to install the new O-rings [A]. Using a high flash-point solvent, clean off any oil or dirt that may be on the silicone sealant coating area. Dry them with a clean cloth. Apply silicone sealant to any two positions of the new O -ring. Sealant - Liquid Gasket, TB1211F: 92104-0 ...

Technical Information-Power Mode
The rider can choose from three engine power modes to suit their preferences and road conditions. The FI ECU controls the engine power by adjusting fuel injection, air intake, and ignition timing. It enables three-mode selection: Full Power (Mode F), Middle Power (Mode M), and Low Power (M ...

Starter Clutch Assembly
Install the one-way clutch [A] to the driven gear. Face the circlip side of the one-way clutch to inside. Install the new snap ring [B] to the one-way clutch. Install the drive gear [C] while turn it counterclockwise [D]. Apply molybdenum disulfide oil solution to the needle bearing ...