Kawasaki Ninja Service Manual: Premuffler Chamber Installation

Kawasaki Ninja Service Manual / Engine Top End / Muffler / Premuffler Chamber Installation

Torque - Premuffler Chamber Mounting Bolt: 34 N·m (3.5 kgf·m, 25 ft·lb)

Premuffler Chamber Installation


Premuffler Chamber Removal
Remove: Muffler Body (see Muffler Body Removal) Right Lower Fairing (see Lower Fairing Removal in the Frame chapter) Front Seat (see Front Seat Removal in the Frame chapter) Oxygen Sensor ...

Exhaust Pipe Removal
Remove: Radiator (see Radiator and Radiator Fan Removal in the Cooling System chapter) Exhaust Pipe Clamp Bolt [A] (Loosen) Remove the exhaust pipe holder nuts [A], and pull out the ...

Other materials:

Battery Installation
Visually inspect the surface of the battery container. If any signs of cracking or electrolyte leakage from the sides of the battery. Put the battery into the rear fender Install the band [A]. Connect the positive (+) cable [B] (red cap) to the positive (+) terminal first, and then ...

ECU Removal
NOTICE Never drop the ECU especially on a hard surface. Such a shock to the ECU can damage it. Remove the upper air cleaner housing (see Air Cleaner Element Replacement in the Periodic Maintenance chapter). Lift up the ECU [A] with rubber protector [B] to disconnect the connectors [C]. ...

Upper Crankcase Assembly
When installing the breather plate, replace the gasket [A] with a new one. Apply a non-permanent locking agent to the threads of the bolts [A] and tighten them. Torque - Breather Plate Bolts: 9.8 N·m (1.0 kgf·m, 87 in·lb) Install the fitting [A] until it is bottomed ...