If any one of them shows visible damage, replace the cap with a new one.
NOTE
Wet the cap sealing surfaces with water or coolant to prevent pressure leaks.
Radiator Cap Relief Pressure Standard: 112 ∼ 142 kPa (1.14 ∼ 1.45 kgf/cm², 16 ∼ 21 psi)
If the cap can not hold the specified pressure or if it holds too much pressure, replace it with a new one.
Engine Oil Flow Chart
1. Oil Screen
2. Oil Pump
3. Oil Pressure Relief Valve
4. Oil Filter
5. Oil Pipe
6. Oil Cooler
7. Balancer Oil Passage
8. Main Oil Passage
9. Crankshaft Oil Passage
10. Oil Pressure Switch
11. Camshaft Oil Passages
12. Drive Shaft Oil Passage
13. Output Shaft Oil Passage
14. Starter ...
Exhaust Pipe Removal
Remove:
Radiator (see Radiator and Radiator Fan Removal in the
Cooling System chapter)
Exhaust Pipe Clamp Bolt [A] (Loosen)
Remove the exhaust pipe holder nuts [A], and pull out the
exhaust pipe [B] forward from the premuffler chamber.
...
KIBS Hydraulic Unit Removal
NOTICE
The KIBS hydraulic unit [A] has been adjusted
and set with precision at the factory. Therefore, it
should be handled carefully, never struck sharply,
as with a hammer, or allowed to fall on a hard
surface.
Be careful not to get water or mud on the KIBS hydraulic
unit.
Drain the b ...