Charging Condition Inspection
Battery charging condition can be checked by measuring
battery terminal voltage with a digital voltmeter [A].
Remove the seat (see Seat Removal in the Frame chapter).
Disconnect the battery terminals.
NOTICE
Be sure to disconnect the negative (–) cable first.
Measure the battery ...
Cylinder Head Installation
NOTE
The camshaft cap is machined with the cylinder head,
so if a new cylinder head is installed, use the cap that
is supplied with the new head.
Install the dowel pins.
Replace the cylinder head gasket with a new one.
Replace the cylinder head bolt washers with new ones.
Apply molybden ...
Immobilizer Amplifier Replacement
Remove the upper fairing assembly (see Upper Fairing
Assembly Removal in the Frame chapter).
Disconnect the connector [A].
Pull out the immobilizer amplifier [B] together with the rubber
protector [C] from the air intake duct [D].
ECU Replacement
Refer to the ECU Removal/Instal ...