Kawasaki Ninja

Kawasaki Ninja Service Manual: Rear Caliper Holder Shaft Wear

Kawasaki Ninja Service Manual / Brakes / Calipers / Rear Caliper Holder Shaft Wear

The caliper body must slide smoothly on the caliper holder shafts [A]. If the body does not slide smoothly, one pad will wear more than the other, pad wear will increase, and constant drag on the disc will raise brake and brake fluid temperature.

If the rubber friction boot is damaged, replace the rubber friction boot. To replace the friction boot, remove the pads and the caliper bracket.

If the caliper holder shaft is damage, replace the caliper bracket.

Rear Caliper Holder Shaft Wear


Caliper Piston and Cylinder Damage
Visually inspect the pistons [A] and cylinder surfaces [B]. Replace the caliper if the cylinder and piston are badly scores or rusty. Front Caliper [C] Rear Caliper [D] ...

Brake Pads
...

Other materials:

Exploded View
AL: Tighten the two clamp bolts alternately two times to ensure even tightening torque. G: Apply grease. R: Replacement Parts G: Apply grease. L: Apply a non-permanent locking agent. R: Replacement Parts Specifications ...

Radiator and Cooling Fan
Check the radiator fins for obstruction by insects or mud. Clean off any obstructions with a stream of low-pressure water. WARNINGThe cooling fan spins at high speed and can cause serious injuries. Keep your hands and clothing away from the cooling fan blades at all times. ...

Radiator and Radiator Fan Installation
If the radiator bracket [A] was removed, install it. Install the radiator fan to the radiator Tighten the radiator fan mounting bolts. When installing the pad [B], install it so that the upper end of the pad aligns with the corner top [C]. When install the pad [D], install it so that the ...