Kawasaki Ninja Service Manual: Rear Caliper Removal

Kawasaki Ninja Service Manual / Brakes / Calipers / Rear Caliper Removal

Rear Caliper Removal


NOTICE

Immediately wash away any brake fluid that spills.

NOTE

If the caliper is to be disassembled after removal and if compressed air is not available, disassemble the caliper before the brake hose is removed (see Caliper Rubber Parts Replacement in the Periodic Maintenance chapter).

Front Caliper Removal
Remove: Bolt [A] Front Wheel Rotation Sensor [B] Loosen the banjo bolt [C] at the brake hose lower end, and tighten it loosely. Unscrew the caliper mounting bolts [D], and detach the ca ...

Caliper Installation
Install the caliper and brake hose lower end. For the front caliper, be sure to install the collars [A]. Replace the washers on each side of hose fitting with new ones. Touch the brake ho ...

Other materials:

For Primary Fuel Injectors
Remove the air cleaner housing (see Air Cleaner Housing Removal). Disconnect the injector connector and connect the harness adapter [A] between these connectors as shown in the figure. Main Harness [B] Primary Fuel Injector #1 [C] Special Tool - Measuring Adapter: 57001-1700 ...

Payload and Tire Pressure
Failure to maintain proper inflation pressures or observe payload limits for your tires may adversely affect handling and performance of yourmotorcycle and can result in loss of control. The maximum recommended load in addition to vehicle weight is 180 kg (397 lb), including rider, passenger, ...

Rider’s Seat Removal
Remove the bolts and seat cover. A. Bolts B. Seat Cover Remove the mounting bolts and pull off the seat upward. A. Mounting Bolts B. Rider’s Seat ...