Run the harness, cables and leads correctly (see Cable, Wire, and Hose Routing section in the Appendix chapter).
Viewed from Upper Side [D]
Viewed from Upper Side [E] Viewed from H-H [F] Viewed from I-I [G] Front Side [J] ZX1000J Model [K] ZX1000K Model [L]
Coupling Bearing Inspection
Since the coupling bearing is made to extremely close
tolerances, the clearance can not normally be measured.
NOTE
It is not necessary to remove the coupling bearing for
inspection. If the bearing is removed, it will need to be
replaced with a new one.
Turn the bearing in the coupling b ...
Oil Pan Installation
If the oil filter holder bolt [A] was removed, tighten it.
Apply a non-permanent locking agent to the threads of
the oil filter holder bolt.
Torque - Oil Filter Holder Bolt: 35 N·m (3.6 kgf·m, 26 ft·lb)
Replace the O-rings [B] with new ones, and apply grease
to them.
Install the O-ri ...
Upper Fairing Assembly Removal
Remove:
Lower Fairings (see Lower Fairing Removal)
Center Inner Fairing (see Center Inner Fairing Removal)
Upper Inner Fairings (see Upper Inner Fairing Removal)
Windshield (see Windshield Removal)
Disconnect the front turn signal light lead connector [A]
(both sides).
Remove the bo ...