Kawasaki Ninja Service Manual: Rear Fender Front Removal

Kawasaki Ninja Service Manual / Frame / Fenders / Rear Fender Front Removal

Remove: Flap and Rear Fender Rear (see Flap and Rear Fender Rear Removal) Fuel Tank (see Fuel Tank Removal in the Fuel System (DFI) chapter) Battery (see Battery Removal in the Electrical System chapter) Exhaust Butterfly Valve Actuator (see Exhaust Butterfly Valve Actuator Removal in the Self-Diagnosis System chapter) Turn Signal Relay [A] Fuse Box [B] Starter Relay [C] Bolts [D]
Clear the cable from the clamp [E].

Rear Fender Front Removal

Clear the harness from the clamp [A].
Remove: Quick Rivets [B] Rear Fender Front [C]

Rear Fender Front Removal

Flap and Rear Fender Rear Installation

Installation is the reverse of removal. Note the following. Fit the tab [A] to the slot [B]. Run the seat lock cable [C] between the tool kit case and the turn signal light as shown in the fig ...

Rear Fender Front Installation

Installation is the reverse of removal. Note the following. Run the harness, cables and leads correctly (see Cable, Wire, and Hose Routing section in the Appendix chapter). When install ...

Other materials:

Valve-to-Guide Clearance Measurement (Wobble Method)
If a small bore gauge is not available, inspect the valve guide wear by measuring the valve to valve guide clearance with the wobble method as indicated below. Insert a new valve [A] into the guide [B] and set a dial gauge against the stem perpendicular to it as close as possible to the cy ...

Front, Rear Wheel Rotation Difference Abnormal Inspection (Service Code b 25)
Check the following and correct the faulty part. Incorrect Tire Pressure Tires not recommended for the motorcycle were installed (incorrect tire size). Deformation of Wheel or Tire Missing Teeth or Clogging with Foreign Matter of Sensor Rotor (see Wheel Rotation Sensor Rotor Inspe ...

Front Fork Removal (Each Fork Leg)
Loosen the front fork top plug [A] beforehand if the fork leg is to be disassembled. Special Tool - Top Plug Wrench (45 mm) [B]: 57001-1741 NOTE Loosen the top plug after loosening the handlebar clamp bolt [C] and upper front fork clamp bolt [D]. Remove: Upper Fairing Assembly (see Up ...