Kawasaki Ninja Service Manual: Rear Master Cylinder Removal

Front Master Cylinder Installation

Apply silicone grease to the sliding surface of the brake lever pivot bolt. Tighten: Torque - Brake Lever Pivot Bolt: 1.2 N·m (0.12 kgf·m, 11 in·lb) Brake Lever Pivot Bolt Nut: 5.9 N· ...

Rear Master Cylinder Installation

Replace the washers that are on each side of hose fitting with new ones. Install the brake hose [A]. Touch the brake hose to the stopper [B] of the rear master cylinder. Tighten: Torq ...

Other materials:

Current Mileage
This display mode shows the current mileage by numerical value. The current mileage display is renewed every 4 seconds. A. Current Mileage B. “km/L” NOTE The display unit modes can be changed, refer to the “Unit Setting” item in this section. The numerical value shows “ ...

Oil Pump Drive Gear Shaft Installation
Apply molybdenum disulfide grease [A] to the oil pump drive gear shaft. Apply molybdenum disulfide oil solution to the followings. Transmission Case [B] Crankcase [C] Install the oil pump drive gear shaft and washer [D] as shown in the figure. Install the new circlip [E] into the ...

Rear Brake Pad Installation
Check that the pad spring is in place on the caliper. Push the caliper piston in as far as it will go. Install the piston side pad [A] first, and then another pad. Fit the brake pad end into the recess [B] of the caliper holder. Install the pad pin and the plug. Tighten: Torque - ...