WARNING Pressurized nitrogen may explode when heated. The rear shock contains nitrogen gas. To avoid an explosion, do not incinerate the shock body without first releasing the nitrogen and removing the shraeder valve. |
WARNING Pressurized gas can cause injury. Do not point the drill toward your face or body. |
Rear Caliper Removal
Remove:
Bolt [A]
Rear Wheel Rotation Sensor [B]
Loosen the banjo bolt [C] at the brake hose lower end,
and tighten it loosely.
Loosen the caliper holder pin [D].
Remove the rear wheel (see Rear Wheel Removal in the
Wheels/Tires chapter).
Unscrew the banjo bolt and remove t ...
Fuel Tank
The following octane rating gasoline
is recommended for the fuel tank.
Avoid filling the tank in the rain or where
heavy dust is blowing so that the fuel
does not get contaminated.
A. Tank Cap
B. Fuel Tank
C. Top Level
D. Filler Neck
WARNINGGasoline is extremely flammable
an ...
Air Intake Duct Assembly (US, CA and CAL Models)
Install the dampers [A] and seal [B] as shown in the figure.
Fit the holder [C] to the air intake ducts [D].
Projections [E] and Holes [F]
Grooves [G] and Ribs [H]
Tighten:
Torque - Air Intake Duct Assembly Screws [I]: 1.5 N·m (0.15
kgf·m, 13 in·lb)
Turn the plug [J] so that ...