Kawasaki Ninja Service Manual: Rear Sprocket Removal

Kawasaki Ninja Service Manual / Final Drive / Sprocket, Coupling / Rear Sprocket Removal

NOTICE

Do not lay the wheel on the ground with the disc facing down. This can damage or warp the disc.

Place blocks under the wheel so that the disc does not touch the ground.

Rear Sprocket Removal


Engine Sprocket Installation
Replace the sprocket washer and axle cotter pin. Install the engine sprocket onto the output shaft. Apply molybdenum disulfide oil solution to the threads and seating surface of the engine sp ...

Rear Sprocket Installation
Install the sprocket facing the tooth number marking [A] outward. Replace the rear sprocket nuts with new ones. Tighten: Torque - Rear Sprocket Nuts: 59 N·m (6.0 kgf·m, 44 ft·lb) Insta ...

Other materials:

Front Master Cylinder Removal
Remove the reservoir mounting bolt and nut [A]. Unscrew the banjo bolt [A] and disconnect the brake hose from the master cylinder (see Brake Hose and Pipe Replacement in the Periodic Maintenance chapter). Unscrew the clamp bolts [B], and take off themaster cylinder as an assembl ...

Rider’s Seat Installation
Insert the tabs on the front of the rider’s seat into the slots in the frame and secure the seat with mounting bolts. Install the seat cover and bolts. A. Rider’s Seat B. Tabs C. Slots D. Stays ...

Lap Counter/Coolant/Intake Air Temperature Meter
This meter shows the coolant temperature, the intake air temperature or the lap number. The lap number is displayed in the stop watch mode, refer to the “Stop Watch” item in this section. A. Lap Counter/Coolant / Intake Air Temperature Meter The coolant temperature meter and inta ...