Kawasaki Ninja Service Manual: Rear Turn Signal Light Bulb Replacement
- Remove the upper seat cover (see Seat Cover Removal
in the Frame chapter).
- Disconnect the tail/brake light connector [A].
- Turn the socket [A] counterclockwise and remove the
socket together with the bulb.
- Push and turn the turn signal light bulb [A] counterclockwise
and remove it.
- Replace the bulb with a new one.
- Insert the new bulb [A] by aligning its pins [B] with the
grooves [C] in the socket, and turn the bulb clockwise
securely.
- Fit the tabs [A] of the socket into the grooves [B] of the
turn signal light housing.
- Turn the socket clockwise.
Another Bulb: Repeat the above steps.
US, CA and CAL Models
- Remove:
Screw [A]
Rear Turn Signal Light Lens [B]
- Push and turn the turn signal light bulb [A] counterclockwise
and remove it.
- Replace the bulb with a new one.
- Insert the new bulb [A] by aligning its pins [B] with the
grooves [C] in the socket, and turn the bulb clockwise
securely.
Check that the “R” (Right) or “L” (Left) mark [B].
- Tighten:
Torque - Rear Turn Signal Light Lens Screws: 1.0 N·m(0.10
kgf·m, 8.9 in·lb)
Another Bulb: Repeat the above steps.
Remove:
Screws [A]
License Plate Light Cover [B]
Pull the bulb [A] out of the socket [B].
NOTICE
Do not turn the bulb. Pull the bulb out to prevent
damage to the bulb. Do not use ...
Remove the battery (see Battery Removal).
Take the turn signal relay [A] off the rear fender.
Disconnect the connector [B].
Connect one 12 V battery and turn signal lights as indicate ...
Other materials:
Headlight Bulb Replacement
Turn the cover [A] counterclockwise, and remove it.
Disconnect the headlight connector [A].
Open the clamp [B], and remove the bulb.
NOTICE
When handling the quartz-halogen bulb, never
touch the glass portion with bare hands. Always
use a clean cloth. Oil contamination from hand ...
Connecting Rod Big End Side Clearance Inspection
Measure connecting rod big end side clearance.
Insert a thickness gauge [A] between the big end and either
crank web to determine clearance.
Connecting Rod Big End Side Clearance
Standard: 0.13 0.38 mm
(0.0051 0.0150 in.)
Service Limit: 0.58 mm (0.023 in.)
If the clearance exceeds ...
Diode Circuit Inspection
Remove the relay box (see Relay Box Removal).
Check conductivity of the following pairs of terminals (see
Relay Box Internal Circuit in this section).
Diode Circuit Inspection
The resistance should be low in one direction and more
than 10 times as much in the other direction. If any dio ...