Kawasaki Ninja Owners Manual: Rebound Damping Force Adjustment

Kawasaki Ninja Owners Manual / Maintenance and adjustment / Rear Shock Absorber / Rebound Damping Force Adjustment

The rebound damping force adjuster is located at the upper end of the rear shock absorber.

A. Rebound Damping Force Adjuster

B. To increase damping force

C. To decrease damping force

Using a screwdriver turn the rebound damping force adjuster clockwise to increase rebound damping or anti-clockwise to decrease it.

NOTICE

Do not turn the rebound damping force adjuster beyond the fully seated position or the adjusting mechanism may be damaged.

Rebound Damping Force Setting

*: This position is the fully seated position (turned fully clockwise).

**: Out from the fully seated position (turned fully clockwise). This adjustment range may not exactly match the number shown in the table due to small tolerance of production.

Rear Shock Absorber Inspection

Press down on the seat several times to inspect the stroke. Visually inspect the rear shock absorber for oil leaks. If there is any doubt about the rear shock absorber, it should be inspe ...

Compression Damping Force Adjustment

The compression damping force adjusters for high and low speeds are located on the gas reservoir at the left side of the rear shock absorber. A. High Speed Adjuster B. Low Speed Adjuster NOT ...

Other materials:

Radiator Fan Relay Inspection
Refer to the Relay Circuit Inspection in the Electrical System chapter If the radiator fan relay is normal, check the wiring for continuity, using the wiring diagram in this section. Special Tool - Hand Tester: 57001-1394 If the wiring is good, check the ECU for its ground and power supp ...

Stem, Stem Bearing Removal
Remove: Upper Fairing Assembly (see Upper Fairing Assembly Removal in the Frame chapter) Front Fender (see Front Fender Removal in the Frame chapter) Front Wheel (see Front Wheel Removal in the Wheels/Tires chapter) Steering Stem Head with Handlebars (see Handlebar Removal) Fron ...

Alternator Rotor Removal
Remove the alternator cover (see Alternator Cover Removal). Clean off the oil from the outer circumference of the rotor. Hold the alternator rotor steady with the rotor holder [A] and suitable washer or plate [B]. Special Tools - Grip [C]: 57001-1591 Rotor Holder: 57001-1666 Flywheel P ...