Kawasaki Ninja Service Manual: Relay Box Removal

Kawasaki Ninja Service Manual / Electrical System / Relay Box / Relay Box Removal

NOTE

The relay box has relays and diodes. The relays and diodes can not be removed.

Relay Box Removal


Relay Box Installation

Stick the pad [A] to the rubber protector [B] as shown in the figure.

Relay Box Installation


Relay Box
...

Relay Circuit Inspection
Remove the relay box (see Relay Box Removal). Check conductivity of the following numbered terminals by connecting the hand tester and one 12 V battery to the relay box as shown in the figure ...

Other materials:

Engine Stop Switch
A. Engine Stop Switch B. START/STOP Switch (for Stop Watch) C. Starter Button In addition to the ignition switch, the engine stop switch must be in the position for the motorcycle to operate. The engine stop switch is for emergency use. If required, move the switch to the  positio ...

Fuels Containing Oxygenates
Gasoline frequently contains oxygenates (alcohols and ethers) especially in areas of the U.S. and Canada which are required to sell such reformulated fuels as part of a strategy to reduce exhaust emissions. The types and volume of fuel oxygenates approved for use in unleaded gasoline by th ...

Oxygen Sensor Heater Resistance Inspection
Turn the ignition switch to OFF. Remove the fuel tank (see Fuel Tank Removal in the Fuel System (DFI) chapter). Disconnect the oxygen sensor lead connector [A]. Connect a digital meter [A] to the terminals in the oxygen sensor lead connector [B]. Measure the oxygen sensor heat ...