If the tester does not read as specified, replace the relay box.
Relay Circuit Inspection (with the battery disconnected)
*: The actual reading varies with the hand tester used.
Relay Circuit Inspection (with the battery connected)
(+): Apply positive lead.
(–): Apply negative lead.
Idle Speed Control Valve Actuator Removal
NOTICE
Never drop the idle speed control valve actuator especially
on a hard surface. Such a shock to the actuator
can damage it.
Remove:
Throttle Body Assy (see Throttle Body Assy Removal in
the Fuel System (DFI) chapter)
Idle Speed Control Valve Actuator Retainer Screws [A]
Idle Spe ...
Wheel Inspection
Raise the front/rear wheel off the ground.
Special Tools - Jack: 57001-1238
Jack Attachment: 57001-1608
Spin the wheel lightly, and check for roughness or binding.
If roughness or binding is found, replace the hub bearings
(see Hub Bearing Removal/Installation).
Inspect the wh ...
Starting the Engine
Check that the engine stop switch is
in the
position.
A. Engine Stop Switch
B. Starter Button
Turn the ignition key to “ON”.
Make sure the transmission is in neutral.
A. Neutral Indicator Light
B. Ignition Switch
C. “ON” position
NOTE
The motorcycle is equipped w ...