Kawasaki Ninja Owners Manual: Right Handlebar Switches

Turn Signal Switch

When the turn signal switch is pushed to the left ( ) or right ( ), the corresponding turn signals blink on and off. To stop blinking, push the switch in. Horn Button When the horn button is pu ...

Engine Stop Switch

A. Engine Stop Switch B. START/STOP Switch (for Stop Watch) C. Starter Button In addition to the ignition switch, the engine stop switch must be in the position for the motorcycle to operat ...

Other materials:

Rear Sprocket Removal
Remove the rear wheel (see Rear Wheel Removal in the Wheels/Tires chapter). NOTICE Do not lay the wheel on the ground with the disc facing down. This can damage or warp the disc. Place blocks under the wheel so that the disc does not touch the ground. Remove: Rear Sprocket Nu ...

Damping Force Adjustment ( ZX1000JC/KC)
To adjust the damping force, turn the damping adjuster [A] until you feel a click. The standard adjuster setting is the 18th click from the 1st of the fully clockwise position. If the damping feels too soft or too stiff, adjust it in accordance with the following table. Damping Force Adj ...

Brake Disc Warp Inspection
Raise the wheel off the ground with the jack. Special Tools - Jack: 57001-1238 Jack Attachment: 57001-1608 For front disc inspection, turn the handlebar fully to one side. Set up a dial gauge against the disc [A] as shown in the figure and measure disc runout, while turning [B] the ...