Kawasaki Ninja Service Manual: Service Code Reading
The service code(s) is displayed on the LCD by the number
of two digits.
NOTE
- The service code of the KIBS and ABS adds “b” at the
left side of the code.
- The service code of the ESD adds “E” at the left side of
the code.
- When there are a number of problems, all the service
codes can be stored and the display will begin starting
from the lowest number service code in the numerical order.
- Then after completing all codes, the display is repeated
until the ignition switch is turned to OFF or upper button
and lower button are pushed for more than two seconds.
- The order of the system’s appearing is the order of
DFI System, Immobilizer System (equipped models),
S-KTRC System, KIBS and ABS (equipped models), and
ESD System (ZX1000JD/KD).
- For example, if three problems occurred in the order of
46, 16, 33, the service codes are displayed (each two
seconds) from the lowest number in the order listed as
shown below.
(16 → 33 → 46) → (16 → 33 → 46) → → ····· (repeated)
- If the no problem or when the repair has been done, warning
indicator light (LED) and warning symbol go off and
service code is not displayed.
NOTE
Use a fully charged battery when conducting
self-diagnosis. Otherwise, the light (LED) and symbol
do not light or blink.
Turn the ignition switch to ON.
When a problem occurs with D ...
When repair has been done, warning indicator light (LED) and warning symbol
go off and service
code are not displayed.
But the service codes stored in memory of the ECU are not erased to preserve ...
Other materials:
Intake Air Pressure Sensor #2 Removal
NOTICE
Never drop the intake air pressure sensor #2 especially
on a hard surface. Such a shock to the sensor
can damage it.
Remove:
Air Cleaner Housing (see Air Cleaner Housing Removal
in the Fuel System (DFI) chapter)
Intake Air Pressure Sensor #2 Connector [A]
Remove the intake air ...
Subthrottle Valve Actuator Input Voltage Inspection
NOTE
Be sure the battery is fully charged.
Turn the ignition switch to OFF.
Disconnect the subthrottle valve actuator connector and
connect the measuring adapter [A] between these connectors
as shown in the figure.
Main Harness [B]
Subthrottle Valve Actuator [C]
Special Tool ...
Oil Filter Replacement
Drain the engine oil (see Engine Oil Change).
Remove the left lower fairing (see Lower Fairing Removal
in the Frame chapter).
Remove the oil filter [A] with the oil filter wrench [B].
Special Tool - Oil Filter Wrench: 57001-1249
Replace the filter with a new one.
Apply grease t ...