If the guide pin on any shift fork is less than the service limit, the fork must be replaced.
Shift Fork Guide Pin Diameter
Standard: 6.9 7.0 mm (0.272
0.276 in.)
Service Limit: 6.8 mm (0.268 in.)
If any shift drum groove is worn over the service limit, the drum must be replaced.
Shift Drum Groove Width
Standard: 7.05 7.20 mm (0.278
0.283 in.)
Service Limit: 7.3 mm (0.287 in.)
Sidestand Installation
Replace the sidestand nut [A] with a new one.
Apply grease to the sliding areas [B].
Tighten the sidestand bolt [C] first, and then the sidestand
nut.
Torque - Sidestand Bolt: 44 N·m (4.5 kgf·m, 32 ft·lb)
Sidestand Nut: 29 N·m (3.0 kgf·m, 21 ft·lb)
Install the spring [D] as sh ...
General Information
All rights reserved. No parts of this publication may be reproduced, stored
in a retrieval system, or
transmitted in any form or by any means, electronic mechanical photocopying,
recording or otherwise,
without the prior written permission of Quality Assurance Division/Motorcycle &
Engin ...
Nozzle Assy Assembly
Before assembling, blow away dirt or dust from the delivery
pipes [A] by applying compressed air [B].
Replace the O-rings [A] of the joint pipe [B] with new ones.
Apply engine oil to the new O-rings, and insert it to the
delivery pipes [C]
Insert the joint pipe so that the step ...