Kawasaki Ninja Service Manual: Sidestand Installation

Sidestand Removal

Raise the rear wheel off the ground with the stand [A]. Remove: Sidestand Switch Bolt [A] Sidestand Switch [B] Remove: Spring [A] Sidestand Nut [B] Sidestand Bolt [C] ...

Footpeg

Footpeg Height Adjustment The front footpeg can be adjusted within 2 positions in height to suit the rider’s preference. Footpeg [A] Bolts [B] Bolt Holes [C] Footpeg Position 1 [D] ...

Other materials:

Check 3-3: High Beam Indicator Light (LED) Inspection
Connect the leads in the same circuit as Check 3-2. Connect the terminal [7] to the battery (+) terminal. Check that the high beam indicator light (LED) [A] goes on. If the indicator light does not go on, replace the meter unit. ...

Piston Wear Inspection
Measure the outside diameter [A] of each piston 5 mm (0.20 in.) [B] up from the bottom of the piston at a right angle to the direction of the piston pin. If the measurement is under service limit, replace the piston. Piston Diameter Standard: 75.959 75.974 mm (2.9905 2.9911 in.) ...

KIBS Hydraulic Unit Inspection
Remove the KIBS hydraulic unit (see KIBS Hydraulic Unit Removal). Visually inspect the connector terminals [A]. Replace the KIBS hydraulic unit or main harness if either of the terminals are cracked, bent, or otherwise damaged. If the KIBS hydraulic unit connector is clogged with mud or ...