Inside Circlip Pliers: 57001-143
Oil Seal & Bearing Remover: 57001-1058
Bearing Driver Set: 57001-1129
Jack: 57001-1238
Bearing Remover Head, 15 ×
17:
57001-1267
Fork Oil Level Gauge: 57001-1290
Bearing Remover Shaft, 13: 57001-1377
Fork Oil Seal Driver, 43:
57001-1530
Hook Wrench T=3.2 R37: 57001-1539
Hook Wrench R=35: 57001-1580
Swingarm Pivot Nut Wrench: 57001-1597
Jack Attachment: 57001-1608
Needle Bearing Driver, 17/
18:
57001-1609
Needle Bearing Driver, 28:
57001-1610
Spacer 28:
57001-1663
Needle Bearing Driver, 20 &
Spacer, 28:
57001-1678
Top Plug Wrench (45 mm): 57001-1741
Rod Guide Case Wrench, 35 mm: 57001-1758
Water Pump Housing Assembly
NOTICE
Do not reuse the mechanical seal and oil seal.
Apply high-temperature grease to the new oil seal lips [A].
Press the new oil seal into the housing with a bearing
driver [B] until it stops at the bottom surface [C] of the
housing.
Special Tool - Bearing Driver Set: 57001-1129
...
KIBS Hydraulic Unit Communication Error (Service Code 1b, KIBS Equipped
Models)
KIBS Hydraulic Unit Communication Line Inspection
When the data (for status of KIBS hydraulic unit) is not
sent from the KIBS hydraulic unit to the meter unit and
ECU, the service code 1b is displayed.
The data is sent through the CAN communication line.
The service code 1b is detected with the ...
Balancer Assemble
Apply molybdenum disulfide oil solution to the ribs of the
balancer [A].
Apply molybdenum disulfide oil solution to the ribs of the
balancer gear [A].
Check that the rubber dampers [B] are in place.
Face the linked portion [C] to the bottom.
Assemble the balancer weight ...