Kawasaki Ninja

Kawasaki Ninja Service Manual: Special Tools and Sealant

Kawasaki Ninja Service Manual / Electrical System / Special Tools and Sealant

Hand Tester: 57001-1394


Flywheel Puller Assembly, M38 × 1.5/M35 × 1.5: 57001-1405


Peak Voltage Adapter: 57001-1415


Lead Wire - Peak Voltage Adapter: 57001-1449


Key Registration Unit: 57001-1582


Grip: 57001-1591


Flywheel & Pulley Holder: 57001-1605


Rotor Holder: 57001-1666


Rotor Holder Attachment: 57001-1689


Key Registration Adapter: 57001-1746


Liquid Gasket, TB1211F: 92104-0004


Exploded View
5. Other than US, CA, and CAL Models 6. The big diameter side of the dampers faces upward. G: Apply grease. L: Apply a non-permanent locking agent. R: Replacement Parts S: Fol ...

Parts Location
1. Timing Rotor 2. Crankshaft Sensor 3. Horn 4. Oil Pressure Switch 5. Rear Brake Light Switch 6. Oxygen Sensor (Equipped Models) 7. Alternator 8. Stator Coil 9. Gear Position Switch ...

Other materials:

Average Mileage
This display mode shows the average mileage by numerical value counted from the start of measuring to present time. A. Average Mileage B. “AV km/L” While the average mileage is displayed, push the lower button and hold it in until the average mileage values resets to “– ...

Moving Off
Check that the side stand is up. Pull in the clutch lever. Shift into 1st gear. Open the throttle a little, and start to let out the clutch lever very slowly. As the clutch starts to engage, open the throttle a littlemore, giving the engine just enough fuel to keep it from stallin ...

Engine Vacuum Synchronization Inspection
NOTE These procedures are explained on the assumption that the intake and exhaust systems of the engine are in good condition. Situate the motorcycle so that it is vertical. Remove: Fuel Tank (see Fuel Tank Removal in the Fuel System (DFI) chapter) Air Cleaner Housing (see Air Cleaner ...