The standard adjuster setting is the 6 turns in from the fully counterclockwise position.
WARNING If both adjusters are not adjusted equally, handling may be impaired and a hazardous condition may result. Be sure the adjusters are set equally. |
Spring Action
Front Wheel Rotation Sensor Removal
NOTICE
The wheel rotation sensor should be handled carefully,
never struck sharply, as with a hammer, or allowed
to fall on a hard surface since the wheel rotation
sensor is precision made. Be careful not to get
water or mud on the wheel rotation sensor.
Do not try to disassemble or repair t ...
Subthrottle Valve Actuator Input Voltage Inspection
NOTE
Be sure the battery is fully charged.
Turn the ignition switch to OFF.
Disconnect the subthrottle valve actuator connector and
connect the measuring adapter [A] between these connectors
as shown in the figure.
Main Harness [B]
Subthrottle Valve Actuator [C]
Special Tool ...
Gear Position Switch Removal
Remove:
Oil Pump (see Oil pump Removal in the Engine Lubrication
System chapter)
Engine Sprocket (see Engine Sprocket Removal in the
Final Drive chapter)
Fuel Tank (see Fuel Tank Removal in the Fuel System
(DFI) chapter)
Disconnect the connector [A].
Remove:
Screws [A]
...