Kawasaki Ninja Service Manual: Starter Clutch Assembly

Starter Clutch Disassembly

Remove the starter clutch (see Starter Clutch Removal). Take the drive gear [A] off the driven gear [B]. Remove the needle bearing [C]. Remove the snap ring [D]. Take the one-way clutch [E] ...

Starter Clutch Inspection

Remove: Torque Limiter Cover (see Torque limiter Removal) Turn the torque limiter [A] by hand. The torque limiter should turn forward freely [B], but should not turn backward. If the start ...

Other materials:

Intake Air Pressure Sensor #1 Installation
NOTE The intake air pressure sensor #1 is the same part as the intake air pressure sensor #2. Installation is basically the reverse of removal. Position the intake air pressure sensor #1 [A] between the projections [B] on the rubber damper. Install the rubber damper [A] on the bracket ...

Coolant Temperature Meter
The coolant temperature gauge indicates temperature of the engine coolant. The “ ” symbol is displayed if the coolant temperature meter is selected. A. Coolant Temperature Meter B. Warning Indicator Light (Red) C. “ ” Symbol If the coolant temperature is below 40°C (104°F ...

Brake Fluid Level Inspection
Check that the brake fluid level in the front brake reservoir [A] is above the lower level line [B]. NOTE Hold the reservoir horizontal by turning the handlebar when checking brake fluid level. If the fluid level is lower than the lower level line, fill the reservoir to the upper lev ...