Kawasaki Ninja Service Manual: Starter Clutch Installation

Kawasaki Ninja Service Manual / Crankshaft/Transmission / Starter Clutch / Starter Clutch Installation

Turn the O-ring side of the shaft to outside as shown in the figure.

Starter Clutch Installation


Starter Clutch Removal
Remove: Torque Limiter (see Torque Limiter Removal) Transmission Assy (see Transmission Assy Removal) Starter Clutch Shaft Holder Bolt [A] Starter Clutch Shaft Bolt [B] Starter Clutch Sha ...

Starter Clutch Disassembly
Remove the starter clutch (see Starter Clutch Removal). Take the drive gear [A] off the driven gear [B]. Remove the needle bearing [C]. Remove the snap ring [D]. Take the one-way clutch [E] ...

Other materials:

Idle Speed Control Valve Actuator Removal
NOTICE Never drop the idle speed control valve actuator especially on a hard surface. Such a shock to the actuator can damage it. Remove: Throttle Body Assy (see Throttle Body Assy Removal in the Fuel System (DFI) chapter) Idle Speed Control Valve Actuator Retainer Screws [A] Idle Spe ...

ECU Identification
Most countries have their own regulations, so each ECU has different characteristic. So, do not confuse ECU with each other and use only the ECU for your model. Otherwise, the motorcycle can not clear the regulation. ECU Identification ZX1000JB/KB ZX1000JC /KC ...

Oil and/or Oil Filter Change
To change the engine oil and replace oil filter, the engine oil drain bolt and oil filter must be removed. The oil change and oil filter replacement should be done by an authorized Kawasaki dealer. A. Engine Oil Drain Bolt A. Oil Filter WARNINGEngine oil is a toxic s ...