NOTE
Do not remove the circlip [C] from the shaft.
ZX1000JC /KC
Models
1. Run the fuse box 2 lead in front of the rib for the fuse box 2.
2. Seat Lock Cable
3. Hook the licence plate light lead and the left turn signal light lead on
the projection of the tool
kit case.
4. Rib for Fuse Box 2
5. Run the starter relay lead in back of the rib for the fuse box 2 ...
Transmission Shaft Assembly
Apply molybdenum disulfide oil solution to the sliding surfaces
of the gears and shafts.
Install the gears and the gear bushings [A] with their holes
[B] aligned.
Replace any circlips removed with new ones.
Install the circlips [A] so that the opening [B] of it is aligned
with ...
System Components
1. KIBS ECU
With input from the front and rear wheel sensors and front
caliper hydraulic pressure, the KIBS ECU analyzes various
conditions on the motorcycle, and with additional information
from the FI ECU (engine speed, throttle position, gear
position, and clutch actuation) precisely control ...