NOTICE
Do not tap the starter motor shaft or body. Tapping the shaft or body could damage the motor.
Stator Coil Installation
Apply a non-permanent locking agent to the threads of
the stator coil bolts and tighten them.
Torque - Stator Coil Bolts: 12 N·m (1.2 kgf·m, 106 in·lb)
Using a high flash-point solvent, clean off any oil or dirt
that may be on the silicone sealant coating area. Dry
them with a clea ...
Crankshaft Sensor Peak Voltage Inspection
NOTE
Be sure the battery is fully charged.
Using the peak voltage adapter [A] is more reliable way
to determine the condition of the crankshaft sensor than
crankshaft sensor internal resistance measurements.
Disconnect the crankshaft sensor lead connector (see
Crankshaft Sensor ...
Shifting Gears
Close the throttle while pulling in the
clutch lever.
Shift into the next higher or lower
gear.
Open the throttle part way, while releasing
the clutch lever.
For smooth riding, each gear position
should cover the proper rate of speed
shown in the table.
WARNINGDownshifti ...