Kawasaki Ninja Service Manual: Starter Motor Removal

Electric Starter System

...

Starter Motor Installation

NOTICE Do not tap the starter motor shaft or body. Tapping the shaft or body could damage the motor. Clean the starter motor legs [A] and crankcase where the starter motor is ground. Rep ...

Other materials:

Seat Cover Removal
Remove: Rear Seat (see Rear Seat Removal) Remove the bolts [A]. Remove the upper seat cover backward [B] to clear the hook portions. Remove: Front Seat (see Front Seat Removal) Quick Rivets [A] Bolts [B] Seat Covers [C] ...

Shift Pedal Installation
Install the rubber damper to the shift pedal. Turn the chamfered side to inside. Assemble: Shift Lever [A] and Locknut [B] (Left-hand Thread) Shift Pedal [C] and Locknut [D] Tie-Rod [E] Turn the grooved end [F] of the tie-rod to the shift lever. Apply grease to the sliding ...

Intake Air Pressure Sensor #2 Input Voltage Inspection
NOTE Be sure the battery is fully charged. Turn the ignition switch to OFF. Remove the air cleaner housing (see Air Cleaner Housing Removal in the Fuel System (DFI) chapter). Disconnect the intake air pressure sensor #2 connector and connect the measuring adapter [A] between these con ...