Kawasaki Ninja Service Manual: Starter Relay Inspection

Kawasaki Ninja Service Manual / Electrical System / Electric Starter System / Starter Relay Inspection

Starter Relay Inspection


Starter Relay Inspection


Starter Relay Inspection


Testing Relay Tester Range: × 1 Ω range

When battery is connected → 0 Ω When battery is disconnected → ∞ Ω

Electric Starter Circuit


1. Ignition Switch

2. Engine Stop Switch

3. Starter Button

4. Gear Position Switch

5. Sidestand Switch

6. Joint Connector E

7. Joint Connector B

8. Battery

9. Main Fuse 30 A

10. Starter Relay

11. Starter Motor

12. Frame Grounds

13. Starter Circuit Relay

14. Relay Box

15. Starter Lockout Switch

16. Ignition Fuse 15 A

17. Fuse Box 1

18. Joint Connector F

Right-hand End Cover Inspection
Using the highest hand tester range, measure the resistance as shown. Terminal Bolt and Right-hand End Cover [A] Terminal Bolt and Negative Brushes [B] Special Tool - Hand Tester: 57001- ...

Lighting System
This motorcycle adopt the daylight system and have a headlight relay in the relay box. The headlight does not go on when the ignition switch and the engine stop switch are first turned on. The head ...

Other materials:

Swingarm Bearing, Sleeve Inspection
NOTICE Do not remove the bearings for inspection. Removal may damage them. Inspect the needle bearings [A] and ball bearing installed in the swingarm. The rollers and ball in a bearing normally wear very little, and wear is difficult to measure. Instead of measuring, visually inspec ...

Crankcase Splitting
Remove the engine (see Engine Removal in the Engine Removal/Installation chapter). Set the engine on a clean surface and hold the engine steady while parts are being removed. Remove: Cylinder Head (see Cylinder Head Removal in the Engine Top End chapter) Starter Motor (see Starter M ...

Wiring Diagram (US, CA and CAL with KIBS Models)
ZX1000KC ZX1000KD ...