Kawasaki Ninja Service Manual: Stator Coil Installation

Kawasaki Ninja Service Manual / Electrical System / Charging System / Stator Coil Installation

Apply a non-permanent locking agent to the threads of the stator coil bolts and tighten them.

Torque - Stator Coil Bolts: 12 N·m (1.2 kgf·m, 106 in·lb)
Using a high flash-point solvent, clean off any oil or dirt that may be on the silicone sealant coating area. Dry them with a clean cloth.
Apply silicone sealant to the circumference of the alternator lead grommet [A], and fit the grommet into the notch of the cover securely.

Sealant - Liquid Gasket, TB1211F: 92104-0004
Secure the alternator lead with a holding plate [B], and apply a non-permanent locking agent to the threads of the plate bolt [C] and tighten it.

Torque - Alternator Lead Holding Plate Bolt: 9.8 N·m (1.0 kgf·m, 87 in·lb)
Install the alternator cover (see Alternator Cover Installation).

Stator Coil Installation

Stator Coil Removal

Remove: Alternator Cover (see Alternator Cover Removal) Holding Plate Bolt [A] and Plate [B] Alternator Lead Grommet [C] Stator Coil Bolts [D] Remove the stator coil [E] from the alternat ...

Alternator Rotor Removal

Remove the alternator cover (see Alternator Cover Removal). Clean off the oil from the outer circumference of the rotor. Hold the alternator rotor steady with the rotor holder [A] and suitabl ...

Other materials:

Service Code Erasing
When repair has been done, warning indicator light (LED) and warning symbol go off and service code are not displayed. But the service codes stored in memory of the ECU are not erased to preserve the problem history. In this model, the problem history can not be erased. However, the memorie ...

Swingarm Bearing, Sleeve Inspection
NOTICE Do not remove the bearings for inspection. Removal may damage them. Inspect the needle bearings [A] and ball bearing installed in the swingarm. The rollers and ball in a bearing normally wear very little, and wear is difficult to measure. Instead of measuring, visually inspec ...

Exhaust Butterfly Valve Actuator Installation
Install the pulley [A] on the actuator so that the hole side [B] align with the groove [C] on the shaft. Make sure that the groove on the shaft is pointing toward the center of the screw [D]. If the shaft position is incorrect, refer to the following NOTE and procedures to electrically ad ...