Kawasaki Ninja Service Manual: Steering Stem Bearing Lubrication

Kawasaki Ninja Service Manual / Periodic Maintenance / Periodic Maintenance Procedures / Steering / Steering Stem Bearing Lubrication

Remove the steering stem (see Stem, Stem Bearing Removal in the Steering chapter).
Using a high flash-point solvent, wash the upper and lower ball bearings [A] in the cages.
Wipe the upper and lower outer races which are press -fitted into the head pipe to clean off grease and dirt.
Visually check the outer races and the ball bearings.

Replace the bearing assemblies if they show wear or damage.

Pack the upper and lower ball bearings in the cages with grease, and apply a light coat of grease to the upper and lower outer races.
Install the steering stem (see Stem, Stem Bearing Installation in the Steering chapter).
Adjust the steering (see Steering Play Adjustment).

Steering Stem Bearing Lubrication

Steering Play Adjustment

Remove: Steering Stem Head with Handlebars (see Handlebar Removal in the Steering chapter). Bend the claws [A] of the claw washer [B] straighten. Remove: Steering Stem Locknut [C] Claw ...

Steering Damper Oil Leak Inspection

Visually inspect the steering damper [A] for oil leakage. If the oil leakage is found on it, replace the steering damper with a new one (see Steering Damper Removal/ Installation in the Steeri ...

Other materials:

Cylinder Head Installation
NOTE The camshaft cap is machined with the cylinder head, so if a new cylinder head is installed, use the cap that is supplied with the new head. Install the dowel pins. Replace the cylinder head gasket with a new one. Replace the cylinder head bolt washers with new ones. Apply molybden ...

Replacement Parts
Replacement parts must be KAWASAKI genuine or recommended by KAWASAKI. Gaskets, O-rings, oil seals, grease seals, circlips, cotter pins or self-locking nuts must be replaced with new ones whenever disassembled. Assembly Order In most cases assembly order is the reverse of disassembly, howe ...

Wheels
Tubeless tires are installed on the wheels of this motorcycle. The indications of “TUBELESS” on the tire side wall and the rim show that the tire and rim are specially designed for tubeless use. A. “TUBELESS” Mark A. “TUBELESS” Mark The tire and rim form a leakproof unit by ...