Special Tool - Steering Stem Nut Wrench: 57001-1100
Special Tool - Steering Stem Nut Wrench [D]: 57001-1100
NOTE
If either steering stem bearing is damaged, it is recommended that both the upper and lower bearings (including outer races) should be replaced with new ones.
Special Tool - Bearing Puller: 57001-135
Moving Off
Check that the side stand is up.
Pull in the clutch lever.
Shift into 1st gear.
Open the throttle a little, and start to
let out the clutch lever very slowly.
As the clutch starts to engage, open
the throttle a littlemore, giving the engine
just enough fuel to keep it from
stallin ...
Starter Motor Installation
NOTICE
Do not tap the starter motor shaft or body. Tapping
the shaft or body could damage the motor.
Clean the starter motor legs [A] and crankcase where the
starter motor is ground.
Replace the O-ring [A] with a new one.
Apply grease to the new O-ring.
Tighten:
Torque - Starter ...
ESD (Electronic Steering Damper) ECU Removal (ZX1000JD/KD)
NOTICE
Never drop the ECU especially on a hard surface.
Such a shock to the ECU can damage it.
Lift up the front portion of the fuel tank, and hold it with a
suitable bar or block (see Fuel Tank Removal in the Fuel
System (DFI) chapter).
NOTE
When removing the ESD ECU only, there ...