Connect the hand tester between the coil terminals.
Set the tester to the × 1 Ω range, and read the tester.
Connect the tester between the plug terminal and (–) coil terminal
Set the tester to the × 1 kΩ range and read the tester.
Stick Coil Winding Resistance
Primary Windings: 0.85 1.15 Ω
Secondary Windings: 5.0 6.8 kΩ
If the tester does not read as specified, replace the coil.
Regulator/Rectifier Inspection
Remove:
Upper Fairing Assembly (see Upper Fairing Assembly
Removal in the Frame chapter)
Right Inner Fairing (see Inner Fairing Removal in the
Frame chapter)
Bolts [A]
Regulator/Rectifier [B]
Set the hand tester to the × 1 kΩ range and make the
measurements show ...
Intake Air Pressure Sensor #1 Installation
NOTE
The intake air pressure sensor #1 is the same part as
the intake air pressure sensor #2.
Installation is basically the reverse of removal.
Position the intake air pressure sensor #1 [A] between the
projections [B] on the rubber damper.
Install the rubber damper [A] on the bracket ...
Gear Position Switch Removal
Remove:
Oil Pump (see Oil pump Removal in the Engine Lubrication
System chapter)
Engine Sprocket (see Engine Sprocket Removal in the
Final Drive chapter)
Fuel Tank (see Fuel Tank Removal in the Fuel System
(DFI) chapter)
Disconnect the connector [A].
Remove:
Screws [A]
...