NOTE
Be sure the battery is fully charged.
Do not remove the spark plugs.
Install the new spark plug [A] into each stick coil [B], and ground them onto the engine.
Connect the peak voltage adapter [C] into the hand tester [D] which is set to the DC 250 V range.
Connect the adapter to the lead wire-peak voltage adapter [E] which is connected between the stick coil connector and stick coil.
ECU [F] Battery [G]
Special Tools - Hand Tester: 57001-1394 Peak Voltage Adapter: 57001-1415 Type: KEK-54-9-B Lead Wire-Peak Voltage Adapter: 57001 -1449
Connections: Adapter (R, +) → Lead Wire-Peak Voltage Adapter (W) Adapter (BK, –) → Lead Wire-Peak Voltage Adapter (R)
WARNING To avoid extremely high voltage shocks, do not touch the spark plugs or tester connections. |
Stick Coil Primary Peak Voltage Standard: 100 V or more
If the reading is less than the specified value, check the following.
Stick Coils (see Stick Coil Inspection) Crankshaft Sensor (see Crankshaft Sensor Inspection) ECU (see ECU Power Supply Inspection in the Fuel System (DFI) chapter)
Spark Plug Removal
Refer to the Spark Plug Replacement in the Periodic Maintenance chapter.
Spark Plug Installation
Refer to the Spark Plug Replacement in the Periodic Maintenance chapter.
ESD (Electronic Steering Damper) ECU Removal (ZX1000JD/KD)
NOTICE
Never drop the ECU especially on a hard surface.
Such a shock to the ECU can damage it.
Lift up the front portion of the fuel tank, and hold it with a
suitable bar or block (see Fuel Tank Removal in the Fuel
System (DFI) chapter).
NOTE
When removing the ESD ECU only, there ...
Front Brake Pad Installation
Check that the pad spring [A] is in place on the caliper.
Push the caliper pistons in by hand as far as they will go.
Install the brake pads [A] on the pad spring correctly.
Fit the pad into the groove of the caliper as shown in the
figure.
Install the pad pins while pushing t ...
Oxygen Sensor Heater Power Source Voltage Inspection
NOTE
Be sure the battery is fully charged.
Turn the ignition switch to OFF.
Remove the fuel tank (see Fuel Tank Removal in the Fuel
System (DFI) chapter).
Disconnect the oxygen sensor lead connector and connect
the measuring adapter [A] between these connectors
as shown in the fig ...