Stick Coil Primary Winding Resistance Inspection
Refer to the Stick Coil Inspection in the Electrical System chapter.
If the reading is within the standard, check the input voltage (see Stick Coil Input Voltage Inspection).
Lubrication
It is important to lubricate rotating or sliding parts during
assembly to minimize wear during initial operation. Lubrication
points are called out throughout this manual, apply
the specific oil or grease as specified.
Direction of Engine Rotation
When rotating the crankshaft by hand, the fre ...
Wheel Bearing Damage Inspection
Raise the front wheel off the ground with the jack (see
Front Wheel Removal in the Wheels/Tires chapter).
Special Tools - Jack: 57001-1238
Jack Attachment: 57001-1608
Turn the handlebar all the way to the right or left.
Inspect the roughness of the front wheel bearing by moving
[A] ...
Battery Removal
Remove the rider’s seat (see Seats
section in the GENERAL INFORMATION
chapter).
Turn the ignition switch to “OFF” and
disconnect the (–) cable from the battery.
Remove the red cap form the (+) terminal,
and disconnect the (+) cables
from the battery.
NOTE
The battery is ...