NOTE
Be sure the battery is fully charged.
If the subthrottle valves do not operate, check the subthrottle valve actuator resistance (see Subthrottle Valve Actuator Resistance Inspection).
Premuffler Chamber Installation
Replace the premuffler chamber gasket [A] with a new
one.
Install the premuffler chamber gasket to the premuffler
chamber [B] until it is bottomed so that the chamfer side
faces exhaust pipe [C].
Install the exhaust pipe clamp [D] as shown in the figure.
Insert the projection [E] into ...
Exploded View
AL: Tighten the two clamp bolts alternately two times to ensure even
tightening torque.
G: Apply grease.
R: Replacement Parts
G: Apply grease.
L: Apply a non-permanent locking agent.
R: Replacement Parts
Specifications
...
Charging Condition Inspection
Battery charging condition can be checked by measuring
battery terminal voltage with a digital voltmeter [A].
Remove the seat (see Seat Removal in the Frame chapter).
Disconnect the battery terminals.
NOTICE
Be sure to disconnect the negative (–) cable first.
Measure the battery ...