Gear Position Switch Output Voltage Inspection
NOTE
Be sure the battery is fully charged.
Turn the ignition switch to OFF.
Remove the fuel tank (see Fuel Tank Removal in the Fuel
System (DFI) chapter).
Disconnect the sidestand switch/gear position switch lead
connector [A].
Connect the measuring adapter [A] between the ...
Tie-Rod and Rocker Arm Bearing Removal
Remove:
Tie-Rod (see Tie-Rod Removal)
Rocker Arms (see Rocker Arm Removal)
Swingarm (see Swingarm Removal)
Sleeves [A]
Oil Seals [B]
Remove the needle bearings [C], using the bearing remover
head and bearing remover shaft.
Special Tools - Bearing Remover Head,
15 ×
17: ...
Armature Inspection
Using the × 1 Ω hand tester range, measure the resistance
between any two commutator segments [A].
Special Tool - Hand Tester: 57001-1394
If there is a high resistance or no reading (∞) between any
two segments, a winding is open and the starter motor
must be replaced.
...