NOTICE
Do not remove the bearings for inspection. Removal may damage them.
The rollers and ball in a bearing normally wear very little, and wear is difficult to measure. Instead of measuring, visually inspect the bearing for abrasion, discoloration, or other damage.
If the needle bearing, and sleeve [B] show any sings of abnormal wear, discoloration, or damage, replace them as a set.
If bearing play, roughness, or binding is found, replace the bearing.
If the seal is torn or is leaking, replace the bearing.
Swingarm Bearing Lubrication
NOTE
Since the bearing are packed with grease and sealed, lubrication is not required.
Lower Crankcase Assembly
Install the ball bearing [A] and the oil level inspection window
[B] until they are bottomed
Apply soap and water solution to the oil level inspection
window before installation.
Install the new circlip [C].
Apply a non-permanent locking agent to the oil passage
plug [D].
Tighten: ...
Thermostat Installation
Replace the O-rings [A] with new ones, and apply grease
to them.
Assemble:
O-rings
Thermostat Housing [B]
Thermostat [C]
Thermostat Cap [D]
Install the thermostat [A] in the housing so that the air
bleeder hole [B] is on top.
Tighten:
Torque - Thermostat Cap Bolts: 5.9 N ...
Engine Stop Switch
A. Engine Stop Switch
B. START/STOP Switch (for Stop Watch)
C. Starter Button
In addition to the ignition switch,
the engine stop switch must be in
the
position for the motorcycle to
operate.
The engine stop switch is for emergency
use. If required, move the switch
to the positio ...